
> Miscellaneous
DA6601
Radiator Muffs
DA4025BLACK DA2160BLACK
262 www.britpart.com
DA2161BLACK
DA2157 DA2163 DA2162
DA2153 Series 2
Series 2A - Early Models
DA4025BLACK Black edging
DA4025BLUE Blue edging
DA4025GREEN Green edging
Series 2A - Late Models
Series 3
DA2160BLACK Black edging
DA2160BLUE Blue edging
DA2160GREEN Green edging
Note - The radiator muffs are black
with either black, blue, brown or
green coloured edging.
Defender
DA2161BLACK Black edging
DA2161BLUE Blue edging
DA2161GREEN Green edging
Discovery
Black edging
DA2153 Discovery 1 - up to LA
DA2157 Discovery 1 - MA onwards
Discovery 2
DA2163
- square headlights
Discovery 2
DA2162
- round headlights
Control the flow of air into your radiator with
a quality British made radiator muff!
X-Defend Pedal Lock
DA6601 Right hand drive
DA6602 Left hand drive
Defender - up to Td5 without air-con
The X-Defend Pedal Lock prevents the clutch, brake and throttle pedal from being operated, making a vehicle almost
impossible to drive! Unlike other pedal locks, this remains bolted to the floor of the vehicle. When not in use, it folds
flat on the floor and seat box, forming the floor of the cab. In this position it can be covered with your usual floor mat.
This means you don’t have to store a 20kg lump of metal which could be lethal if it hit you in the event of an accident
or while off-roading. It also means that locking is incredibly quick. Just release the catch which holds it against the seat
box and lock into position. A 10mm thick steel claw grabs the brake pedal shaft and ratchets in tight against it. It can
be locked in a couple of seconds! To unlock turn the key which releases the pedal and fold flat on the floor. The Pedal
Lock is supplied in tough, corrosion proof 304 stainless steel and uses formed hinges with a 6mm stainless pin. It is
supplied with an anti-drill, British made Lowe & Fletcher RPT Lock. Notes - This does NOT fit Series/Defender - 2007
onwards. As not all Defenders are the same and build tolerances are at best acceptable it may be necessary to either
relocate the bonnet pull bracket (you can drill out the spot welds and re-attach with pop rivets) or better still replace with
the later Td5 type bonnet pull (FSC000050PMA). We have discovered that because Land Rover had no set place to fit
the early type bracket it sometimes fouls the pedal lock.
DA1398 2-door kit
DA1399 4-door kit
The Bombproof Hinge Guard is built to exact specification
and was developed to fit all Defender models and years.
It has been engineered for maximum protection and
ease of fitment. Each Hinge Guard kit consists of two
CAD engineered stainless steel plates which fit inside of
each hinge point, restricting outward movement of the
door with the bulkhead bolts removed. Fitting the Hinge
Guards is incredibly easy with comprehensive fitting
instructions supplied. Each door kit can be easily fitted in
20-30 minutes. After installation, only the top of each plate
can be seen, providing an unobtrusive modification and
deterrent to would-be thieves.
Features
> Notched upper guard - fits neatly around the dash
padding without compromising security.
> Custom folds - each plate has a carefully measured,
very small offset to allow it to close around the door
frame without tearing the door seal.
> High-Grade 304 Stainless Steel - 2mm thick: thin
enough to fit unobtrusively, more than thick enough to
protect your hinges.
> Individually profiled - lower and rear hinges profiled for
a perfect fit across all variants.
Door Hinge Guards
See them in action at
www.britpart.com/bombproof
DA1399
Defender door fitting kit.
Ideal to keep handy if
removing the door cards
at any time. Front or rear
single door.
2 x Lokut-nut
12 x Fasteners
DA1411 Grey kit
DA1412 Black kit
Black kit with
DA4649
clips & snapsacs
EXCLUSIVE DA1412
to Britpart!